![]() If water sprays out the spray tips will need to be cleaned.Turn the machine on and press the trigger for 5-10 seconds or until you see water.With the spray tip removed, use a pair of pliers to squeeze the metal clamp behind the spray tip and pull the spray tip out of the spray line.Remove one spray tip by pressing the sides in and pulling it up and out. ![]() Remove the water tank from the front of the machine to expose the floor spray tips.Next check the spray tips for the floor.If still no spray continue troubleshooting.If spray comes out of the hose, but not on the floor a new tank should be ordered Create a Guide I Have This Support Questions Ask a Question Background and Identification The Bissell ProHeat 2X Cleanshot is a part of the ProHeat line of Bissell carpet cleaners.Test for spray from the hose and to the floor.Next check the collection tank by removing the tank and putting the solution tank (filled with water) on the clean water receiver and turning the cleaning dial to water rinse.Press up on the x in the red rubber gasket on both tanks to see if water comes out, if no water comes out a new tank or formula tank should be ordered (formula tank not applicable to the 1383).Fill both the tank and the solution tank with tap water.Detach the front nozzle from the machine. Unplug the machine from the wall power socket and pull out the tank for clean water. Empty the clean water tank and let dry before storing. Line up the three hooks on the nozzle to the bottom of the foot. At the bottom of the upper handle, align the clean water tank with the grooves and slide the tank into place. Return the nozzle back to the foot of the machine. Now, you're ready to power it on and test it before you start cleaning. Hold the nozzle and insert the nozzle clean out tool in to the thin slot on the end of the nozzle that touches the floor. Stand the machine upright and plug it into an outlet. Push the bare floor attachment into the nozzle and toward the appliance from the back and it should click into place. clean the water that was just sucked up from the dirty tank. Locate the tabs on the attachment and line them up with the nozzle on the machine's underside. Release the spray trigger and suck up the water. If there is no gasket on the cap of either the tank or Smartmix Solution tank check for it in the base of the machine, if it is missing a new tank cap should be ordered In case the machine cleans the carpet and leaves behind streaks, the following troubleshooting steps could help you fix the problem. Turn the machine on and press the spray trigger for 15 seconds while making back and forth passes on a section of carpet.Release the trigger and make another forward and reverse pass. While holding down the trigger make one forward and reverse wet pass. Look at both the caps for the tank and Smartmix solution tank to ensure that a red, rubber gasket is in place for proper solution dispensing The following simple steps will ensure a long life for your BISSELL ProHeat 2X: Flush the system by setting the Custom Clean knob to the 'Rinse' Setting.Check that the tank lid is properly attached to the tank bottom with the nozzle hooked into the groove at the bottom of the tank, and secured with the gray latch
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |